3D Printed/Hybrid DIY Glock slide – Will it Work?


After the last test (which was a joke, effectively), Boostwillis came up with this great idea – threaded rods and reinforcing plates throughout the slide to give it a chance of holding up. Will it work? Let’s find out!

I’m Ivan – a fella who works to document and record the history and technical background of the development of homemade firearms.

You can support me directly on Utreon –

You may know me from my work with ARES Research to help author reports about this topic – this channel shows the “behind the scenes” testing that goes into building the body of knowledge requied.

Regardless of if you are here for the research, technology, or just to see some funky looking guns tested, I hope you enjoy.

**All firearms shown and tested are done so in full compliance will all applicable laws. All test firing and use of firearms is conducted on a properly zoned, legally operated firing range.**

Source link

What do you think?

Written by admin

@Basilikos3 @Alfuzy1 I think this might be more about hating for being unstoppa

👻👻👻👻👻👻 oooo so scarryy