3D Printed MP5 But I Forgot The Flanges


Testing out a couple experimental changes to the KF5 – one being the paddle mag release, the other being the flangleless upper.

The paddle release will likely be included with the initial release of the KF5, but the flangleless upper will take a lot of testing – if the idea doesn’t hold up it won’t be released. The flanges offer important stiffness to the parts, and it remains to be seen how they perform without them. But I figured I’d share this experimental version to show you guys some of the behind the scenes testing that goes into these things.

I’m Ivan – a fella who works to document and record the history and technical background of the development of homemade firearms.

You can support me directly on Utreon –

You may know me from my work with ARES Research to help author reports about this topic – this channel shows the “behind the scenes” testing that goes into building the body of knowledge requied.

Regardless of if you are here for the research, technology, or just to see some funky looking guns tested, I hope you enjoy.

**All firearms shown and tested are done so in full compliance will all applicable laws. All test firing and use of firearms is conducted on a properly zoned, legally operated firing range.**

Source link

What do you think?

Written by admin

Message me if you need a Gold Glock switches going fast Glock

GST9 MOD1 custom STL