admin
Just for knowledge sharing… printed in polymaker pa6-gf with bambu breakaway support for pa. sliced using bambu studio. Wanted to test how clean you could get the supported parts using the breakaway support material.
Here were the support settings (everything else came from the readme.. chairmanwon 19x v3 – standard)
-
Top z – distance 0
-
bottom z-distance .12
-
Top interface spacing 0.
Great print, little disappointed with the performance of the breakaway support materia, it does not release from itself -or- the pa6 very well. This is going to require more sanding than I was expecting. The finish and layer adhesion of the supported material is excellent though (no first layer over support poor layer adhesion)
bambu clean
yellow is the break away support material clinging for dear life.
