"Between the Ribs" Push Dagger V1.0.1


“Between the Ribs” Push Dagger V1.0.1: Laffs Dynamics

An offset T-handle push dagger with a double edged blade. One side transitions from a straight edge, then slopes
forwards towards the tip. The other side is a straight blade with a wide tanto styled tip.

This slender design is suited for reaching organs between and under the rib cage.

Update V1.0.1: Changed recommended print settings for better device strength, updated name of designer.

Printer Used: Ender 3 V2

Filament Used: PLA+

Print Settings:

Extruder: 220C
Bed: 56C
First Layer Print Height: .20mm
Standard Layer Height: .12mm
Wall Thickness: .40
Wall Perimeters: 8+
Infill: 50%+

Note: Due to this specific push dagger’s slim design, it’s HIGHLY recommended to print with at LEAST 8+ walls for best
durability within it’s intended design parameters.

Source link

@UOLNoticias Eles não tem mais o poder de violar sua liberdade. Quem quiser sabe

Long Action AICS Mag Progress (30-06 based cartridges) : fosscad