admin
Evo Edgerunner Grip (CZ Scorpion Evo 3): Laffs Dynamics
Wake the Fuck Up Samurai; We have Soiled Undies to Burn D:
Skeletonized styled grip for the Scorpion Evo III. Built in reinforcement struts to resist damage against impacts on hard surfaces.
A grip for the masses to stand up to megacorpos; for those that love to run on the bleeding edge of 3DP2A tech.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .14mm – .16mm
Wall Thickness: .40
Wall Perimeters: 5+
Infill: 35%
Support Material Percentage: 18%
Print the grip upside-down.
Hardware Required:
1x M4x30mm Bolt (Can be ground down to 28mm so it doesn’t stick out the side)
1x M4 Hex Nut
Source link
