First test print

So I just got my printer, took basically two days of setting it up, went to print my bed level, came out good. So I did a calibration cube, came within .02mm on all sides, printed benchy which came out even better than I expected so I figured screw it let’s go for a test print. I attached pictures, just looking for input. All things considered I cannot believe how well it came out. I copied settings someone shared on here for the same file a while back. This is some older sunlu pla+ I had from my wife’s printer so idk if it’s moist or not, I plan on using polymaker for the build thoughpictures

I left it untouched to get assessment right off the press