More KF5 Testing – 3D Printed MP5


A little more testing with the KF5 – this time, trying out the Aves MP5 ejector with a variety of magazines. The Aves ejector functioned perfectly and took no hand fitting to install – it’s pretty awesome!

I’m Ivan – a fella who works to document and record the history and technical background of the development of homemade firearms. You may know me from my work with ARES Research to help author reports about this topic – this channel shows the “behind the scenes” testing that goes into building the body of knowledge requied.

Regardless of if you are here for the research, technology, or just to see some funky looking guns tested, I hope you enjoy.

**All firearms shown and tested are done so in full compliance will all applicable laws. All test firing and use of firearms is conducted on a properly zoned, legally operated firing range.**

Source link

@realMarkBoyer @KeneAkers Nope. Not tired whatsoever… matter of fact, I’ve tra

2nd print stock settings at .16 layer height. damn near perfect except for the 2 dings I put in it!