in 3D2A

Rails up… Rails down… Don’t matter. Use PETG as support interface layer when printing PLA+. I don’t have a MMU, but really need to see this happen.

1.4k Views


Rails up… Rails down… Don’t matter. Use PETG as support interface layer when printing PLA+. I don’t have a MMU, but really need to see this happen. submitted by /u/ConstantWin943
[comments]



Source link

What do you think?

0 Points
Upvote Downvote

Written by admin

9mm UPC Mag Catch

AOC Stiffs Service Workers Who Glammed Her Out For Ritzy Event